These IEC power supplies have been especially developed for the education market over many years.
Image
Code
Description
Each
Quantity
LQ2612-001
IEC HIGH VOLTAGE LABORATORY POWER SUPPLY The IEC High Voltage Power Supply (2x 6.3V.AC @ 4amps, 0-300V.AC / 0-500V.DC @50mA) is a general purpose power supply that can supply high voltage up to 50mA. The overload trip is electronic and is reset by turning off the high voltage output. The low voltage is provided as 2x 6.3V.AC. 4A outputs which are normally used for running heaters of electron tubes.
$509.30
LQ2615-001
IEC EXTRA HIGH VOLTAGE LABORATORY POWER SUPPLY The IEC extra high voltage power supply (2x 6.3VAC @ 4amps), (3,000/0/3,000V.DC) is an important and special power supply for running Spectrum tubes or Teltron tubes or for charging Aepinus capacitors or many other functions. Designed to have very poor regulation such that as current is drawn, the voltage falls quickly. Upon a short circuit, the current is limited to 3mA for safety for students. The low voltage is provided as 2x 6.3V.AC. 4A outputs which are normally used for running heaters of electron tubes.
$605.00
LQ2645-001
IEC REGULATOR MODULE 1.25 - 15VDC 1AMP This IEC Regulator Module can be connected to any AC or DC power source and will convert the AC or unfiltered DC to a smooth, adjustable, metered and regulated output of 1.2 to 15V.DC at 1A for electronic studies. Input and output is via 4mm sockets. The small meter monitors output voltage. If the input voltage is low, the output may not achieve 20volts. For 20 volts output, an input of close to 14V.AC is required.
$155.00
LQ2646-001
IEC REGULATOR MODULE MULTI OUTPUT 1AMP This Dual Output IEC Regulator Module can be connected to any AC or DC power source and will convert the AC or unfiltered DC to a smooth, adjustable, metered and regulated dual positive & negative output of 1.2 to 15V.DC at 1A. Input and output is via 4mm sockets. The small meter monitors output voltage. If the input voltage is low, the output may not achieve 20volts. For 20 volts output, an input of close to 14V.AC is required.
$155.00
PS1690
IEC SWITCHABLE POWER SUPPLY 5 AMP This famous IEC Power Supply is a compact, general purpose power supply to provide switched AC and DC voltages at 2, 4, 6, 8, 10 and 12V.AC and DC up to 5A. The DC output is full wave rectified but not filtered. Still the original and the best!
$165.00
PS1695
IEC LABORATORY POWER SUPPLY This very popular IEC "Dual Mode" Power Supply combines both AC/DC switched and DC smooth and regulated power outputs. It is suitable for both general lab work and electronic studies where a smooth and regulated output is necessary. Overload protection is automatic for both modes of operation. The meter on the regulated section can be switched to monitor either output volts or output amps. The switched section provides AC and DC at 2, 4, 6, 8, 10 and 12V at 8A and the regulated section provides 1.3V to 20V.DC. at 5A reducing to 2A at the lower voltages.
